EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (6 topics).
6 topics · 30 messages
Filtered by: ADAU1452M ✕
-
Project Stops Running after about 1 minute. 1452, Tone, Parametric EQ, Stimulus/Probe
I am running a simple project with a couple GPIO pins to illuminate the onboard LEDS (as a visual 'hearbeat' that the app is running), a couple 5 band parametric EQs and Level Controls. I also have tw
-
EVAL-ADAU1452MINIZ no output on channels 2-7
I have a simple schematic executing on the EVAL-ADAU1452MINIZ that generates a sine wave and outputs it to a serial output channel to the AD1938. I can observe this sine wave when it's connected to ch
-
EVAL-ADAU1452MINIZ load from microcontroller
I'm having trouble loading the DSP on a EVAL-ADAU1452MINIZ board using our microcontroller. The code is stable and ported from our ADAU1701 target hardware, with the changes required for the ADAU1452.
-
ADAU1452 Eval board filters & output problems
Hi, I am new with this board and with DSP, so please forgive me if my questions sound stupid. I want to use this evaluation board as a crossover for experimentation. Specifically I'd like to feed the
-
Controlling DSP on EVAL-ADAU1452MINIZ evaluation board
Hello, I'm planning to use the above development board to develop a prototype of a complete system and application. On the final design, the system should have an MCU controlling the DSP operation (ch
-
adau1452minz with SigmaStudio 3.11 loading eeprom
Using ADau1452minz and SigmaStudio 3.11 build 2 rev 1396. The adau1452 is amazing, and SigmaStudio is a very easy to use GUI. My project is sounding great!!!!!!! However, I have been unsuccessful at d