EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (10 topics).
10 topics · 39 messages
Filtered by: #adau+1467 ✕
-
Simple Router
Dear all I expected that the only difference between "Simple Router" and "Simple Router with slew", is the slew. In real time capture I see that the controls are completely different to change input.
-
Wav Player
Dear all I use two WAV Player in my sketch. According to Wiki, the audio file must not exceed the size of the available DMO memory. Adau 1467 has 20,480 words (32 bits). Does this mean that 81,920 byt
-
SPI Read Module for Block Shematic
Dear Team, The data in EEPROM memory can be read in schematic using SPI Read module. But in Block schematic there is no equivalent spi read Module. How to read data in EEPROM memory in block schematic
-
Adau 1467 it does not work
hello sorry for my bad english I have an adau 1467, unfortunately it doesn't work, it doesn't let any sound in or out of the log input if i press compail download it makes a short pips sound but nothi
-
AEC Trial Version
Hi, AEC trial version gets muted In 10 minutes during self-boot mode before 30 minutes (Documented). Audio Signal Processors software sigmaStudio 4.7 adau1467 sigma studio 4.7 SigmaDSP Audio Processor
-
AEC ADAU 1467
Hi, AEC trial version gets muted In 5 minutes before 30 minutes (Documented). Block shows 88 seconds instead of 1800 seconds as shown in figure.
-
how to connect a bluetooth device (headphone or speaker box) in a2dp bluetooth profile, and in sink role, to an eval adau 1467Z board ?
Hello I would like to send one or many stereo outputs of my eval adu 1467Z board to some cheap off the shelf hardware which will convert it to wireless (bluetooth) so that it can be received by any ma
-
what are the possible options for summing Left and right signal into mono signal ?
hi all, I would like to know what are the different possible ways to mix L & R signal of a stereo audio input flow into a mono signal output. The immediate use case is to derive a mono subwoofer chann
-
conditional switching
Hi, I want to achieve following: If the input goes to one, the output will go to one, then if the input turns into a "0" , the output will have to go to "0" without delay or hold. Then the output must
-
Timer in adau 1467
Hi, I want to utilize timer in adau1467. Requirements: If input=1, output=1 (without any delay or hold) If input=0, output=0 (output stays at zero for 30ms no matter whatever input is). Audio Signal P