EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (9 topics).
9 topics · 55 messages
Filtered by: #adau1467+evaluation+board ✕
-
ESP32 SPI control of ADAU1467 parameter RAM on EVAL-ADAU1467Z — writes not taking effect
I'm trying to control an ADAU1467 on the EVAL-ADAU1467Z evaluation board from an ESP32 microcontroller via SPI on the J1 slave control port header (the same header used by the USBi). Setup: EVAL-ADAU1
-
Sigmastudio+ EVAL-ADAU1467Z write EEPROM/selfboot
Hello, what do I need to do to write the EEPROM of EVAL-ADAU1467Z with Sigmastudio+ 2.4 and USBi and get it running in selfboot mode? When I create a new project and connect the PC with USBi and the U
-
Looking for a detailed guide on configuring ADAU1467 I/O routing (ports, pins, and SigmaStudio correlation)
Hello, dear friends, I’m working with the ADAU1467 on the standard EVAL-ADAU1467Z evaluation board, and I’m struggling to fully understand how to configure input/output routing so that it matches what
-
Assignment drive strength/slew rate/pulldown register to SDATAIOx-pins is NOT bijectiv
You would assume a bijectiv, simple assignment between the drive strength/slew rate/pulldown registers and SDATAIOx - Pins: register F7Bx correponds to Pin SDATAIOx (see datasheet p199). But this is n
-
Anti Noise Setup for machines (ANC) with EVAL-ADAU1467Z, problems with broadband recordings
Hello Forum, we are using an ADAU1467 Evaluation Board to build an ANC setup in an anechoic chamber (for testing purposes). We are using big JBL Boxes and play back a broadband recording of a machine.
-
How can i get the VAD flag status on the evaluation board
Hello, i'm lit a bit lost with the use of the GPIO/MP and VAD flag block. Do you have any recommandation to know on the EVB if there is some voice acitivity in the DSP ? I'm interested to use any MPx
-
Microphone MI-3111 doesn't work
Hello, I have an adau1467 eval board. I connected my MI-3111 microphone and stereo output to the board and read the adau1467 user guide. But I want to get sound from the microphone and output from my
-
Adau1467 expand I/O ADC and DAC
Dear sir/madam, As I am working with the Adau1467, I'm running out of ADC and DAC pins. For this application I would like to use at least 6 microphones, 1 audio input and 14 DAC outputs. I could use t
-
Audio Stream stopping after several seconds
Can load the program into the board no problem but then the audio stream stops after 5-20 seconds. Even monitoring in sigma studio shows that the signal cuts out. This is very similar to this issue: A