EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (6 topics).
6 topics · 29 messages
Filtered by: #configuration ✕
-
Regarding the issue of the ADAU1787's power-on startup, the normal power supply (DVDD) does not output any voltage.
Hello! I made a circuit board that consists of 3 ADAU1787 chips and one MCU.However, I have encountered some problems recently. I have attached my AD project files and a screenshot of the ADAU1787 har
-
Configuration of ADAU1467 multipurpose pins MPx
Hello, I am using EVAL-ADAU1467Z and SigmaStudio+ 2.3.0. In the user guide, one can read that MP15, MP14 and MP7 are connected to DIP Switch S3. These pins are dedicated IO pins, i.e. not multiplexed
-
ADAU1467 full range external input n-channel compressor gain step size (RMS (no gain) N-Channel RMS Compressor with Ext. Detect)
In our new product we are shifting from adau1442 to adau1467. We are controlling the dsp through an mcu and must therefore fully understand what is what in the register map. There are several good exp
-
ADAU1466 Serial Port 2 Configuration
I am looking for assistance with setting up Serial Input Port 2 as an I2S input using SigmaStudio 3.17. I have created a project with a Input block with channels 32-33 selected. This connects to a two
-
ADAU1451 Core sample rate settings
Hello. I have a question regarding the sample rate setup of the ADAU1451 using SigmaStudio 3.14. I am running my application on a custom board with a 24.576 MHz MCLK with all four I2S input data chann
-
Problem with FIR filter frequency cut and sampling frequency
Hello everyone, I'm quite new with DSP programming, so here is my problem : I have an EVAL-ADAU1761Z and I am using SigmaStudio. What I wish to do is to use 7th order filters (so the only solution is