EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (11 topics).
11 topics · 45 messages
Filtered by: #direct ✕
-
SigmaStudio+ Indirect Parameter Accees Table
In old SigmaStudio you could add a parameter to the IPAT with a simple mouse right-click. Is there a similar feature in SigmaStudio+? I can only add it via the IPAT table but it gets annoying when the
-
Indirect Parameter Access Table
Hi, Having issues with the IPAT. I have enabled the proper options, built a table, did the update, recompiled and then stored to EEPROM. For some reason, I cannot access the IPAT addresses, just the o
-
adau1466
Hello Support Team Guys, Now one of our customers is facing an issue that one of modules in the export system files contains indirect address,but it doesn't contain direct address. without direct addr
-
How to map Indirect Parameter Access parameters to GUI controls?
I am learning about the Indirect Parameter Access and can't locate any documents that correlate the gui controls on schematic components to the parameters listed for indirect access. Some are obvious
-
ADAU-1701 - direct headphones connection
Hi ADI! We're working on a new prototype with our custom PCB design based on 1701; we got everything working until now with input from ext microphone (ampop amplified), 1701 with selfboot and external
-
Indirect Parameter Access Table
Hello, there are some new parametersets in the selection box concerning the params of the moduls: current... and target... (see picture) What do i have to choose to write new values? Marc DSP: Adau 14
-
Hierachy boards and indirect parameter access table
I have a design in SigmaStudio 4.5 using the ADAU1452 with hierachy boards where, for instance I have 4 output channels which have the same processing map. So each channel has an identical Hierachy bo
-
Indirect Parameter Access Table Read/Write to same parameter
Hi, i would like to perform both reading than writing to a parameter but don't know how to. In the wiki is explained that two separate indirect addresses should be used but looks like the image is mis
-
About indirect parameter module
Dear support member Can Indirect parameter module avoid pop and click noize like a sofoware safeload registers? If no, could you tell me how to avoid them when we use Indirect parameter module, please
-
Need help correcting speaker frequencies
Hi, On request of a friend we're building an omnidirectional bluetooth speaker. Because space is very limited we bought an ADAU1701 to correct the sound for it. One of the problems we're facing is the
-
Use of an ADAU1761's input to control VCDelay
Hello, I have an EVAL-ADAU1761Z and SigmaStudio. I wish to control the value of a VCDelay (from 0ms to 80ms) with an external signal. How can I do ? I thought about using an ADC input and an external