EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (9 topics).
9 topics · 37 messages
Filtered by: #sigmastudio+bug_5f00_report ✕
-
Bug in 'New Item Sampling Rate"
Here are steps to reproduce the problem: 1. Create SigmaStudio dspproj as described in the ADAU1787Z Evaluation Board User Guide. See attachment. Note the 'New Item Sampling Rate" is 48 kHz. and confi
-
SigmaStudio obfuscation generates invalid Mono IL
Hello, It seems that (for very questionable reasons), the release of SigmaStudio has been "obfuscated" to an extent that it is no longer valid .Net. Indeed Linux full supports .NET an should be able t
-
[BUG REPORT] After dragging and dropping a node onto the schematic, clicking anywhere before waiting for a few moments adds duplicate nodes
I'm using SigmaStudio 4.6 and have noticed a consistent issue that occurs when dragging and dropping nodes from the ToolBox onto the schematic. After dropping the new node onto my schematic, if I clic
-
SigmaStudio COM interface Python example fails
I'm trying to put together a demo on Windows that will use a Python (3.8) program to retrieve some I2C values from peripherals in a Sigma Studio schematic. (it's an A2B network schematic). I followed
-
SigmaStudio 4.5 crash on launch - Win 10 64bit, .Net 4.8 installed
Hello, A fresh install of SigmaStudio 4.5 on Windows 10 64 bit crashes on startup. I installed .Net framework 4.8 (latest) and rebooted. There doesn't seem to be any debug information available. Any s
-
[BUG REPORT] [ADAU1452] High order Shelving Table Interpolator with Ext gain or not, trigger "index out of range exceptions" and totally locks any file saved that contains them.
Sigma 4.5. Steps to reproduce: start a blank project add one of those filters grow them to more than one cell (grow algorithm) save close try to load again The use of this module also comes with a var
-
[Bug Report] SigmaStudio.3.13: Different parameter values in exported files
I would like to report a bug regarding the exported files from SigmaStudio. I am currently using ver 3.13. The DSP is the ADAU1701. I have seen in the Release note for 3.14 that the following is a kno
-
ADAU145x software safeload address changes, not included in header file
See page 80 of the 145x datasheet. It says that the software safeload addresses are determined by the compiler, so they may differ from the "defaults". This is indeed true... and it says to look at co
-
[Bug Report] Scripting: Delay block - can't change MAX to larger value
The following script command will modify MAX delay samples value only if new value is lower than existing one: res = ss.ObjectSetProperties("setControlValue", delay_1_name, 0, 0, "DelaySamples`max", 2