EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (8 topics).
8 topics · 40 messages
Filtered by: #sigmastudio+v4_2e00_7 ✕
-
TDM2 oder 8 channels
Hey together, one question. We know that it is possible to send 16 channels of audio via serial port 0/1 via a single SDATA pin (16 channels), via 2 SDATA pins (2x8channels) and 4 SDATA pins (4x4chann
-
Design support for AGC funtion
Hi, I'm looking for an AGC function in the SigmaDSP part for leveling an input signal within a certain range, coming from an unknown voice source (various types of radios). It's seems there is not a b
-
LIMIT ON ADAU1701
Hello! "Hello everyone. I have a question about limiting on the ADAU1701. I'm working with an input board on an active speaker. I’ve tried feeding it the highest signal I have — a 1kHz sine wave at 3V
-
ADAU1452 – Ripple/distortion occurs at low signal levels when using the xover filter.
The signal is distorted, similar to the blue response curve, when the volume is low using the General (2nd-Order / Lookup) filter on the ADAU1452. With other filters, this issue does not occur. I also
-
metronome
Does anybody have an idea how to build a tap tempo metronome ? The click of the metronome could be a pulse generator. The tapping ( with a push-button GPIO ) should be in sync with the outgoing metron
-
Single Level Detector w Numeric Display component display error at some input signal level in SigmaStudio
Hi ADI team I found the Level Detector w Numeric Display component in the SigmaStudio display a error value at some input signal level. Below is my DSP project for test Level Detector w Numeric Displa
-
USBi programmer behaving abnormally
Hello, I am using USBi with SigmaStudio v4.7. I also have ADAU1701 mini eval board, and my own target board with ADAU1701, EEPROM socket and USBi interface header. The discription of the issue is as f
-
ADAU1466 T Connection Latency
Hi, I have a problem with a project for ADAU1466. I have detected a latency difference between two channels of 1 sample. I have been reducing my schematic until I find the problem and I have found it