EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (5 topics).
5 topics · 17 messages
Filtered by: #v4-5 ✕
-
Filter Boost Gain is wrong
Dear Team, We are using the following Filter Module When using the Filter , we have observed that when setting the gain in the slider , there is always a -5dB difference from expected. Can you confirm
-
Sigma DSP Audio Output Stops
Dear Team. I am trying to interface my ADAU1452 REV BZ board with another SHARC hardware as shown below: These are the settings in Sigma STudio . Issue occurs once I connect the GND or SDATAOUT0 pin t
-
Custom boot support in Sigma
Dear Team, In SHARC Processor, Custom Booting is supported. Can we Implement custom booting in Sigma DSP ADAU1452 processor? If supported, please share the procedure for implementing Custom Boot in Si
-
Reading EEPROM Memory in Sigma Studio
Dear Team, We are using the Flash Programmer available as inbuilt module in Sigma Studio to flash a binary file into the EEPROM Memory. The EEPROM memory in the ADAU1452 Rev BZ Board is an 25AA1024 -
-
Multiple definitions in IC_1_PARAM.H
Hi, I have seen that when I export my project so I can integrate it with my mcu code. I am getting multiple definitions in "IC_PARAM.H" file. I have a made a very basic project to show the issue I am