EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (10 topics).
10 topics · 57 messages
Filtered by: #2_2e00_2_2e00_0 ✕
-
the example code of LMS adaptive filter
Hello, one of our customers would like to eavlaute ADAU1797 if it is OK for ANC. They would like to purchase EVAL-ADAU1797Z to try the algorithm of LMS adaptive filter. In order to support the custome
-
Can't expand screen to full width of 2 monitors
trying to screen capture a very wide diagram but can't make SS+ span 2 monitors, i.e. place window on left monitor and try and stretch it to the right and it stops at one monitor's width. software ss+
-
Sigma Studio+ Memory Calculation Error
When compiling the attached project in SigmaStudio+ the memory calaculations are showing for 48kHz even though all of the blocks in the schematic are set to 96khz. Have you come across this before? Br
-
How to use Phat - Stereo
Hello, I'm a biginer engineer on Sigma Studio. I try to use Phat-Studio's algorithm on ADAU1452, and I tried implementing it like the attached image. However I can't feel what was changing by Phat-Stu
-
How to set sample rate in SS+ like done in 4.7?
I'm sure I've missed something obvious, but a search of the Wiki/docs (with "sample rate"@resources:tools-software:sigmastudiov2) did not turn up anything. Where has this from 4.7: gone in SS+? I have
-
Example that consistently hard crashes SS+ 2.2.0 upd 2
Open the attached. Select the Stream Configuration (this seems to be a factor to make it fail), and let it link. Select the System tab Open the 2nd to last sub node (shown selected in above capture) D
-
Help doesn't work without an internet connection
SS+ seems to think there's no internet connection on my PC even though it's fine. So I guess that's bug #1. Bug #2 is help doesn't work because it thinks there's no internet connection. It should prov
-
External SPI Delay on multiple channels shared with SRAM?
Dear ADI community, I'm currently planning to build an algorithm/architecture for the ADAU1466 where each of 8 outputs gets the option to set up to pretty high delay at 96 kHz (up to 1 second per chan
-
ADAU1467 PLL
Hi I'm designing a DSP base on ADAU1467. I have some question about hardware and software. In SigmaStudio+ software Version 2.2.0. ADAU1467 IC settings, CLOCK CONTROL, there is a tab named CLK_GEN3 in
-
SigmaStudio+ ADAU1452 unable to write EEPROM?
Hello, I've been trying for hours to get a board with an ADAU1452 and an EEPROM (SPI on the master of the ADAU1452) to run. My problem: With SigmaStudio 4.7 everything works perfectly. With SigmaStudi