EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (9 topics).
9 topics · 26 messages
Filtered by: #a2b ✕
-
Error during generate XML file
Good morning, I have a problem when I try to generate the XML file to use during the discovery of A2B network to configure the peripheral of eval board. When I click on Generate XML, SigmaStudio open
-
ADAU1452 – No TDM8 Output on Serial Port 0 (Clock Slave to AD2428)
Hello, I am having trouble getting the ADAU1452 to output TDM8 data on Serial Port 0. Hardware setup: I am using the EVAL-AD2428WD1BZ, which includes an onboard ADAU1452. For testing, I want to genera
-
ADAU1467 TDM16 problem
Hello, I'm working on a custom A2B subordinate board. The subordinate transceiver get 16 streams from A2B network and generates a TDM16 towards a ADAU1467 with the input serial port 1 configured like
-
Fault monitor on GPIO's.
Hello all, Looking for some guidance on this project. I using a ADAU 1467, driving 5 amp chips and is part of A2B system. I want to send fault and warning flags from the amps and A2B network. I want t
-
Example that consistently hard crashes SS+ 2.2.0 upd 2
Open the attached. Select the Stream Configuration (this seems to be a factor to make it fail), and let it link. Select the System tab Open the 2nd to last sub node (shown selected in above capture) D
-
Need to work with A2B. Got dsproj files for ADAU1761.
Normally I am a Linux user. I work with Yocto and the Android AOSP. Now I need to work with A2B, so I fought for a Windows computer to run SigmaStudio. I downloaded SigmaStudio 4.7 and installed it. H
-
Decimation - Output sampling rate
Hi, I have adau1452 sigmaDSP on an A2B chain and this dsp streams data to the host (SC589-SAM). The adau1452 receive samples from an accelerometer and is programmed with a decimation block via sigma s
-
How to read certain address in ADAU1452 memory
Hi, I am trying to control the ADAU1452 dsp with ADI SC589 via i2c writings on A2B. I am able to write and read registers and memory of the adau1452. I want to read certain memory addresses in the ada
-
Unable to access AD2420
I am new to Sigma Studio. I want to use AD2420 with Sigma Studio. I have connected it to my desktop using Ethernet. But, still it is not showing up when I start a new project in Sigma Studio. Please l