EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (120 topics).
120 topics · 677 messages
Filtered by: #adau1446 ✕
-
Evaluate modulation methods for ultrasonic array
Hello I have an EVAL-ADAU1466Z board and I want to use it for a 40kHz parametric loudspeaker array project. My goal is to evaluate different modulation methods like PWM, SSB, AM, etc. My question is,
-
ADAU1442 hardware design
Hello All, We are developing a product where we need to interface 6 I2S ports to the processor. Due to limitations in number of channels on the processor side, We decided to have a dedicated Codec/DSP
-
ADAU1466 and I2C Operation
I need to use I2C to control an ADAU1466, rather than the serial SPI. I have used an eval board with its serial SPI interface to verify operation of my ADC and DAC circuits (I2S out and in to ADAU1466
-
ADAU144x and ADAU1962 TDM8 serial output configuration.
Hello, I'm having troubles setting the serial ports to TDM8, I've previously worked with 2 channel DACs and SigmaDSP but this has me stumped. ADAU1962 is master in standalone mode, TDM8 pulse. ADAU144
-
opcode generation error
Hi, I'm using ADAU1446 Audio DSP. During connecting sigmastudio to HW, "opcode generation error" was occurred. When I tried "Link Project", No errors were occurred, but I tried "Link Compile Connect"
-
adau144x TDM8 on scope
Hi , I am new to working with TDM8 24bits I have adau144x working in master mode The DSP is working in pulse mode in TDM8 24bit mode. I have delayed by one set ( i2s mode ) So I calculate there should
-
adau1446 input / output continuity
Hi, I have TDM2 16bit I2S selected on input 4 TD8 16bit I2S selected for output 4 on the adau1446. I'm switching clock domain 4 SD pin from input to output mode and switching the input/output on/off d
-
adau144x SD input output question
Hi, I'm using ADAU1446 with ARM Dev board and TDM recording and playback is working. Unfortunately the Dev board only supports one SD TDM pin on its Serial Audio Interface although I can configure it
-
How to load different end-user presets on a adau1701 without MCU
Hi, I'm using a ADAU1401/1701 DSP for some of our projects, but I want to be able to load completely different sigma studio project files, preferably with a dip switch, or with a single button that ro
-
Help with ADC noise in one channel please.
Hello, Setup: 2 channel ADC set up as master into ADAU1446, as slave. I'm having a slight problem in that I am getting full range noise (white noise/hiss) on one channel of my ADC, only when a signal
-
Intermittent noise with ADAU1446 application
Hi. We're a speaker company and have a new power amplifier application that's using ADAU1446 DSP with AD1939 CODEC. The amp has 4 x analogue inputs, 4 x Class D power amplifier outputs and 2 x line le
-
Problem with ADAU1452 and External SPI Delay @96Khz
Hello everyone, I'm developing an application using ADAU1452 and Sigmastudio 3.14. I'm trying to use External Delay Block but unfortunately it seems that there is no way to use that block with a syste
-
ADAU1446 errata, delay on SDATA_IN0 and one clocking question.
Dear AD support, we're in the middle of evaluating the ADAU1446 as a central part of a multi-DSP, multichannel audio solution. After initial tests with the official EVM, we're currently doing measurem
-
Can I run TDM16 at 96kHz?
I have done a few designs using ADAU1446 and ADAU1442 in which we run the chip from a 24.576 MHz crystal so I have done TDM8 interfaces at 96kHz without problems. Now I see from the data sheet that AD
-
Multitone "Sine tone" - how many?
Hello I would like to build multitone (sine 1/3 octave) generator for testing audio equipment. How many sine tone block I can place into ADAU1701 (preffered) or ADAU1446? I can find any information in
-
Spikes on MPIO outputs
I designed and built a board using the ADAU1446. I have done several other projects with I2S, but this is my first time with a DSP. The ADAU1446 is connected via I2C to a Raspberry Pi. The DSP respond
-
Help locate adau1446 pin #1 dot
I'm trying to find the pin #1 dot, on the ADAU1446 (100-Lead Thin Quad Flat Package [LQFP]). I have tried examining the package with a magnifying glass, but I just can't see it. Is pin #1 near the sam
-
sweep in 1446
Hi, I use Source->logrithimic Sweep->Sweep(lookup/sine) in the ADAU1446. But I don't how to use the host to recall it. Can you give me an example and its details? Tell me how to calculate its paramete
-
ADAU1446 SPDIF recovered Clock as Master
Hi Is it possible you use the recovered clock from the SPDIF receiver to be the clock source for the SDATA and DSP Core My Project uses external Codec IC as a slave that is connected to SDATA , and ju
-
adau1446 create dc offset
I have an application with a dc coupled output that has some dc offset on it. Is there a way to generate the equivalent of a dc offset( a shift away from midpoint) in the output of the ADAU1446 to com
-
Problems with ADAU1772
Hello, I have finally received prototype PCBs for a new design using ADA1772 and ADAU1446. The DSP chip is acting as the master and providing the MCLK for the CODEC. In attempting to setup the signal
-
Concerned about crystal/clock swing level/ ADC noise issue.
Hello, I'm slightly concerned that the amplitude of my clock signal is too great. Attachment 'PIN41_27PF' shows the signal at pin 41 of my ADAU1446 (after the 100R resistor), measured using an inch lo
-
SigmaStudio Schematic Problem
Hello! I have a big problem with my SigmaStudio schematic at the moment. I made a schematic for a 4-way loudspeaker on our custom board with the ADAU1446. It worked very well in different variants and
-
How to use a Sigma Processor in a product
I recently emailed technical support and they asked that I post my inquiry on the forum: Inquiry Description: Hi, My name is Justin and I'm new to the DSP world. My expertise is analog audio electroni
-
monitoring signals in time domain
Hello community, we use SigmaStudio plus ADAU1446 Eval kit and we are interested in monitoring the signals using kind of Probe in time domain. I wonder if there is any feature available in sigmastudio